Home Brew Tire Deflator

Bill of Materials

• 1 - 0-30# Pressure gauge with 1/4" NPT fitting
  
  Ordered from www.gaugestore.com. 0-30# gauge is more accurate for low pressures, but care should be taken not to subject it to pressure above 30#. A 0-60# gauge coule be used.
  
  
• 1 - Brass Tee with 1/4" NPT
• 1 - Air nozzle
  
  Located with air compressor supplies at hardware store. I found mine at WalMart
  
  
• 1 - Air chuck with safety connector
• 2 - 1/4" hose barb with 1/4" male NPT fitting
• 2' - 1/4" rubber hose
• Teflon tape
  

Assemble the parts using Teflon tape to seal connections. Use grease to push tubing onto barbs. Hose clamps could be used to secure hose to barbs, but they were not needed on mine.